1 - | Shim for “K 1” |
Determining thickness → Chapter. |
2 - | Large engaging lever for “K 1” |
With engagement bearing |
Removing and installing → Chapter |
3 - | Hinge mounting |
For large engaging lever “K 1” |
Cannot be renewed. |
4 - | Small engagement bearings for “K 2” |
5 - | Shim for “K 2” |
Determining thickness → Chapter. |
6 - | Upper section of bushing |
For small engaging lever “K 2” |
Is removed and installed together with small engaging lever and lower section of bushing |
7 - | Small engaging lever for “K 2” |
Is removed and installed together with upper and lower section of bushing |
Removing and installing → Chapter |
8 - | Ball pin |
For small engaging lever “K 2” |
Removing and installing → Anchor |
9 - | Bolt |
Always renew after removing. |
8 Nm +90° |
10 - | Lower section of bushing |
For small engaging lever “K 2” |
Is removed and installed together with small engaging lever and upper section of bushing |
Removing and installing fresh air blower -V2-, LHD vehicles
Note
If only the fresh air blower -V2- is defective, remove and
install fresh air blower control unit -J126-
→ Chapter.
Removing
Fresh air blower -V2- is accessible from footwell on front
...
Removing and installing ignition/starter switch
Removing
–
Remove lower steering column trim
→ General body repairs, interior; Rep. gr.68.
–
Disconnect electrical connector -1-.
...
Air conditioner compressor without magnetic clutch, with elastic drive
coupling
The air conditioner compressor is driven directly by the
power steering vane pump.
There is an overload protection on the drive shaft of the
air conditioner compressor, which shears in the event of the air
conditioner compressor seizing, ...