Volkswagen Golf Service & Repair Manual: Assembly overview - camshaft housing, engine codes CHPA, CMBA, CPVA, CXSA, CZCA, CPVB, CZDA

Volkswagen Golf Service & Repair Manual / 4- cylinder injection engine(1.4 1 direct inction. turbocharger) / Engine cylinder head, valve gear / Cylinder head / Assembly overview - camshaft housing, engine codes CHPA, CMBA, CPVA, CXSA, CZCA, CPVB, CZDA

Assembly overview - camshaft housing, engine codes CHPA, CMBA, CPVA, CXSA, CZCA, CPVB, CZDA

1 -

Bolt

Specified torque and tightening sequence → Fig.

2 -	Inlet camshaft control valve 1 -N205-

Removing and installing → Chapter

3 -

Bolt

8 Nm

4 -	Camshaft housing

Removing and installing → Chapter

5 -	Hall sender -G40-

Removing and installing → Chapter

6 -

Bolt

8 Nm

7 -

Seal

For exhaust camshaft, gearbox end

Renew → Chapter

8 -	Toothed belt pulley

For coolant pump.

Removing and installing → Chapter

9 -

Bolt

Specified torque → Item

10 -

Bolt

8 Nm

11 -

Cap

12 -

O-ring

Renew

13 -

Gasket

Renew

14 -

Dowel pin

15 -

Gasket

With oil strainer

Inserted into cylinder head

Note

The oil strainer is fitted only if the cylinder head has the appropriate recess.

Cylinder heads with recess do not require an oil strainer.

16 -

Seal

For inlet camshaft.

Renew → Chapter

17 -

Seal

For exhaust camshaft (pulley end)

Renew → Chapter

18 -

Cap

Camshaft housing - specified torque and tightening sequence

Note

Renew bolts that are tightened with specified tightening angle.

–	Tighten bolts in stages in the sequence shown:

Assembly overview - camshaft housing, engine codes CHPA, CMBA, CPVA, CXSA, CZCA, CPVB, CZDA

Stage	Bolts	Specified torque/ additional specified angle
1	-1 … 15-	10 Nm
2	-1 … 15-	Turn 180° further

Assembly overview - cylinder head

Note The camshafts must not be removed individually. In the event of repair, the camshaft housing must be renewed complete ...

Removing and installing cylinder head

Special tools and workshop equipment required Socket -3410- Removing ...

Other materials:

Removing and installing shock absorber, multi-link suspension, left shock absorber
Special tools and workshop equipment required Torque wrench -V.A.G 1332- Torque wrench -V.A.G 1410- Spring compressor -V.A.G 1752/1- Spring retainer -V.A.G 1752/3A- Adapter -V.A.G 1752/9-, not illu ...

Matting additive -LVM 769 810 A2
Designation: Matting additive -LVM 769 810 A2- Issued 10.2014 Product description The matting additive -LVM 769 810 A2- is an additive for 2-pack HS clear coats and 2-pack HS ...

High-pressure sender -G65
This high-pressure sender -G65- is fitted in place of the air conditioning system pressure switch -F129-. When voltage is applied to the high-pressure sender, it generates a square wave signal, or data telegram. This signal changes when ...