Volkswagen Golf Service & Repair Manual: Assembly overview - brake pedal, RHD vehicles
The brake pedal travel must not be restricted by additional floor
coverings. |
Note
Do not lubricate or grease the pivot pin. The pivot pin must remain
dry. |
Removing and installing
→ Chapter |
Insert into both holes in mounting bracket. |
To remove, remove mounting bracket first |
Removal: turn pivot pin clockwise until pivot pin tabs break off |
Do not lubricate or grease the pivot pin. The pivot pin must remain
dry. |
Installation: Turn pivot pin anti-clockwise until tabs engage
audibly on stop. |
Cannot be renewed individually; ensure correct installation position |
Separating brake pedal from brake servo
→ Chapter |
Connecting brake pedal to brake servo
→ Chapter |
Removing and installing
→ Chapter |
For ball head of brake servo plunger rod. |
Cannot be renewed individually; ensure correct installation position |
The brake pedal travel must not be restricted by additional
floor coverings.
Note
Do not lubricate or grease the pivot pin. The pivot ...
Special tools and workshop equipment
required
Release tool -T10159-
–
...
Other materials:
Removing and installing tail light in rear lid
Note
Removal and installation are described for the left side.
Removal and installation on the right side are carried out in
the same way.
If the event of a defective LED, the entire tail light needs
to be rene ...
Removing and installing track rod
Special tools and workshop equipment required
Torque wrench -V.A.G 1332-
Open-end insert, 38 mm -V.A.G 1923-
Ball joint puller -T10187-
Locking pliers for Phaeton steering rack -VAS 6199-
...
Assembly overview - fog lights, GTI and GTD
1 -
Bolt
Specified torque: 2 Nm
2 -
Bolt
Specified torque: 2 Nm
3 -
Fog lights
These LEDs cannot be renewed. If one of the LEDs fails, the entire
fog light needs to ...
© 2016-2024 Copyright www.vwgolf.org