Volkswagen Golf Service & Repair Manual: Assembly overview - brake pedal, RHD vehicles
Note
The handbrake pedal travel must not be restricted by additional
floor coverings. |
Do not lubricate or grease the pivot pin. The pivot pin must remain
dry. |
Removing and installing
→ Chapter |
Insert into both holes in mounting bracket. |
To remove, remove mounting bracket first |
Removal: turn pivot pin clockwise until pivot pin tabs break off |
Do not lubricate or grease the pivot pin. The pivot pin must remain
dry. |
Installation: Turn pivot pin anti-clockwise until tabs engage
audibly on stop. |
Cannot be renewed individually; ensure correct installation position |
Separating brake pedal from brake servo
→ Chapter |
Connecting brake pedal to brake servo
→ Chapter |
Removing and installing
→ Chapter |
For ball head of brake servo plunger rod. |
Cannot be renewed individually; ensure correct installation position |
Note
The handbrake pedal travel must not be restricted by
additional floor coverings.
Do not lubricate or grease the pivot ...
Remove dash panel end cover on driver side
→ General body repairs, interior; Rep. gr.70.
–
Remove footwell cover on driv ...
Other materials:
Repairs to wiring with cross sections up to 0.35 mm2
Special tools and workshop equipment
required
Crimping pliers, complete -VAS 1978/1 A-
Head adapter 0.35 mmІ - 2.5 mmІ -VAS 1978/1-1-
For repairs to ...
Vents
Fig. 184 In the dash panel: vents
First read and observe the introductory information
and safety warnings Vents
The vents should be left open to ensure that the vehicle interior is sufficiently
heated, ventilated and cooled.
Turn the relevant thumb wheel (magnified view) in the req ...
Removing and installing evacuating and charging valves on low and
high-pressure side
Special tools and workshop equipment
required
Torque wrench -V.A.G 1783
Ratchet insert 1/4 inch -VAS 6234
...
© 2016-2024 Copyright www.vwgolf.org