Volkswagen Golf Service & Repair Manual: Assembly overview - brake pedal, LHD vehicles
Note
The handbrake pedal travel must not be restricted by
additional floor coverings. |
Do not lubricate or grease the pivot pin. The pivot pin must
remain dry. |
|
|
|
1 - |
Self-locking hexagon nut |
Always renew after removing |
To remove, remove mounting bracket first |
Removal: turn pivot pin clockwise until pivot pin tabs break off |
Do not lubricate or grease the pivot pin. The pivot pin must remain
dry. |
Installation: Turn pivot pin anti-clockwise until tabs engage
audibly on stop. |
3 - |
Pedal cluster with mounting bracket |
Removing and installing
→ Chapter |
Cannot be renewed individually; ensure correct installation position |
Separating brake pedal from brake servo
→ Chapter |
Connecting brake pedal to brake servo
→ Chapter |
Removing and installing
→ Chapter |
Cannot be renewed individually; ensure correct installation position |
For ball head of brake servo plunger rod. |
Insert into both holes in mounting bracket. |
Note
The handbrake pedal travel must not be restricted by additional
floor coverings.
Do not lubricate or grease the pivot pin. The pivot pin must remain
...
Other materials:
Removing and installing Hall sender 3 -G300-
Removing
–
Release hose clips -1- and
-2-, and remove air pipe.
–
Disconnect electrical connector -1-.
...
Flat connector systems
Note
If necessary, any housing catches in place (secondary
locking mechanisms) must be released or removed prior to
disengaging the contacts using the prescribed tool
→ Chapter.
...
Assembly overview - cylinder block, gearbox end
Note
For assembly work, secure engine to engine and gearbox support
→ Chapter.
1 -
Bolt
Renew
60 Nm + 90°
2 -
Flywheel
Removing and installin ...
© 2016-2024 Copyright www.vwgolf.org