Volkswagen Golf Service & Repair Manual: Assembly overview - Bowden cable
- From gearbox to release lever
- Forms one part with gearbox and cannot be renewed individually
- 5 Nm
- Needs to be renewed after each removal of gearbox
- If one Bowden cable is damaged, the entire gearbox needs to be renewed,
together with both
Bowden cables
- Needs to be renewed after each removal of gearbox.
- 5 Nm
- Needs to be renewed after each removal of gearbox
- Always needs to be renewed together with bolts
- 3 Nm
- Always need to be renewed together with cover
- From gearbox to release lever.
- Forms one part with gearbox and cannot be renewed individually.
- In the interior, bolted to cross panel
Note
Minor differences will be encountered on removal and
installation, depending on version.
The specified torques refer on ...
Removing
Note
Minor differences will be encountered on removal and
installation, depending on version.
...
Other materials:
Assembly overview - rear parking aid, LHD vehicles
1 -
Electrical connector
2 -
Spreader clip
3 -
Rear parking aid warning buzzer -H15-
Removing and installing
→ Chapter
4 -
Spreader clip
5 -&n ...
Removing and installing suspension strut
Special tools and workshop equipment required
Torque wrench -V.A.G 1332-
Spreader -3424-
Engine and gearbox jack -V.A.G 1383 A-
Support -T10149-
Special tools and workshop equipment
...
Introduction
This chapter contains information on the following subjects:
→ Vehicle identification data
→ Engine data
→ Dimensions
→ Performance figures
The vehicle data sticker in the service schedule or the vehicle registration
documents show which engin ...
© 2016-2024 Copyright www.vwgolf.org