VW Golf manuals

Volkswagen Golf Service & Repair Manual: Assembly overview - belt pulley, Denso air conditioner compressor

Volkswagen Golf Service & Repair Manual / Heating, air conditioning / Air conditioner / Air conditioner compressor / Assembly overview - belt pulley, Denso air conditioner compressor

Assembly overview - belt pulley, Denso air conditioner compressor

1 -  Bolt
Qty. 3.
4.5 Nm
2 -  Sealing cap
3 -  Nut
25 Nm
–  To unfasten and tighten the hexagon nut, hold the pulley in position with a commercially available oil filter strap wrench.
4 -  Drive plate
With overload protection. Deploys in the event of excessive torque (e.g. if the air conditioner compressor cannot rotate freely). The belt pulley then rotates without driving the air conditioner compressor.
5 -  Circlip
Renew.
Do not reverse when installing (flat side faces air conditioner compressor).
6 -  Belt pulley
Different versions. Refer to → Electronic Parts Catalogue.
Sensitive to impact, handle with care
Removing and installing → Chapter.
7 -  Air conditioner compressor
Clean drive shaft of air conditioner compressor before fitting the belt pulley.
Assembly overview - drive unit of air conditioner compressor, Golf GTE
1 -  Electrical air conditioner compressor -V470- With control unit for air conditioner compressor -J842- and electrical air conditioner compressor -V470 ...

Assembly overview - belt pulley, Sanden air conditioner compressor
1 -  Nut 25 Nm   Note In order to protect the thread of the air conditioner compressor drive shaft an additional plastic cap i ...

Other materials:

Assembly overview - steering column switch module, with mechanical ignition lock
1 -  Ignition key 2 -  Lock cylinder Removing and installing → Chapter 3 -  Immobiliser reader coil -D2- Removing and installing → Chapter 4  ...

Without needing to purge refrigerant circuit of contaminants (e.g. damage in an accident); no refrigerant has escaped and no moisture or dirt has entered refrigerant circuit
Drain refrigerant circuit. –  Renew restrictor. Depending on vehicle –  Remove receiver or reservoir. –  Clean any dirt out of receiver or reservoir. ...

Overview of fitting locations - components not located in passenger compartment, Golf Variant LHD
1 -  Exhaust ventilation for passenger compartment Checking → Chapter Removing and installing → Chapter 2 -  Ambient temperature sensor -G17- Removing and installing ...

© 2016-2024 Copyright www.vwgolf.org