Volkswagen Golf Service & Repair Manual: Assembly overview - auxiliary heater, interior
| 1 - | Bolts |
| 7 Nm |
| 2 - | Heat exchanger |
| Removing and installing → Chapter. |
| 3 - | Seal |
| Must be renewed after every opening. |
| Note fitting position. |
| 4 - | Burner tube |
| Removing and installing → Chapter. |
| 5 - | Glow plug with flame monitoring -Q8- |
| Ensure correct seating. |
| Removing and installing → Chapter. |
| 6 - | Cover for auxiliary heater control unit -J364-. |
| Removing and installing → Chapter. |
| 7 - | Cover |
| 8 - | Auxiliary heater control unit -J364- with combustion air blower -V6- |
Note| The auxiliary heater control unit -J364- and the combustion air blower -V6- with housing form one component and cannot be dismantled. The reason is the seal between the auxiliary heater control unit -J364- and the housing. |
| 9 - | Noise insulation |
| 10 - | Cover |
| Removing and installing → Chapter. |
| 11 - | Coolant connection |
| Mark installation position before detaching |
| 12 - | O-rings |
| Renew. |
| 13 - | Retaining plate |
| 14 - | Bolt |
| 4 Nm |
| 15 - | Coolant connection |
| Mark installation position before detaching |
| 16 - | Temperature sensor -G18- |
| Removing and installing → Chapter. |
| 17 - | Retaining spring |
| 18 - | Bolt |
| 4 Nm |
| 19 - | Overheating sensor -G189- |
| Removing and installing → Chapter. |
Assembly overview - auxiliary heater attachments
1 -
Auxiliary heater
2 -
Clamping piece
3 -
Coolant hose
4 -
Air intake silencer
...
Removing and installing auxiliary heater
Special tools and workshop equipment
required
Torque wrench -V.A.G 1410- (4…20 Nm)
...
Other materials:
Removing and installing brake servo, RHD vehicles with diesel engine
Note
If there are problems with the brake servo, first check the
brake servo vacuum system
→ Chapter.
Special tools and workshop equipment required
Release tool -T10159 ...
Removing and installing coolant pump for high-voltage battery -V590-
Special tools and workshop equipment
required
Hose clamps, up to 25 mm -3094-
Hose clip pliers -VAS 6362-
...
Removing and installing washer jets
Removing
Note
Removal and installation are described for the left side.
Removal and installation on the right side are carried out in
the same way.
–
Remove pop-up cylinder
→ ...
