Volkswagen Golf Service & Repair Manual: Assembly overview - alternator with sliding bushes
| Removing and installing
→ Chapter |
| Removing and installing poly V-belt pulley
→ Chapter |
| Removing and installing voltage regulator -C1-
→ Chapter |
| Ensure that bushes slide freely and are not too tight (loosen, if
necessary), as clamping force of a stiff bush will be insufficient even
when the correct torque is applied. |
| Only on vehicles with TDI engine |
| Only on vehicles with TDI engine |
1 -
Bolt
Qty. 4
Specified torque: 23 Nm
2 -
Alternator -C-
Removing and installing
→& ...
Special tools and workshop equipment
required
Torque wrench -V.A.G 1331-
Removin ...
Other materials:
Wear in middle of tyre
This wear pattern is found on the driven wheels of
high-performance vehicles that are frequently driven long
distances at high speeds.
At high speeds, centrifugal forces cause the tyre diameter
to increase more in the middle of the tread ...
Work instructions
Unbolt relevant brake line at brake caliper or wheel brake
cylinder; catch escaping brake fluid and dispose of this as per
regulations.
–
Cut through brake line at a suitable point (straigh ...
Removing and installing backrest heating element -Z7-/-Z9-
Removing
If the backrest padding in a vehicle with seat heating is
renewed, then the respective backrest heating element must also
be renewed.
–
Separate backrest cov ...
© 2016-2024 Copyright www.vwgolf.org
Assembly overview - alternator without sliding bushes
Removing and installing alternator, vehicles with 1.2 l TSI engine, 1.4 l
TSI engine and 1.4 l TSI natural gas engine