Volkswagen Golf Service & Repair Manual: Assembly mountings

Installing engine

Procedure Engine/gearbox assembly secured to engine support T10497.   Note Renew bolts that are tightened w ...

Assembly overview - assembly mountings

1 -  Bolt Renew Tightening sequence → Fig. 2 -  Engine support Specified torque and ti ...

Other materials:

Condenser
The condenser transfers heat from the compressed refrigerant gas to the surrounding air. This allows the refrigerant gas to condense into liquid form.   ...

Removing and installing rear lid seal
In the factory a sealant is applied to the rear lid seal, the seal is fitted to the body flange and then rolled on. Note When the seal is removed, the sealant on the inside of the seal will be spread and the flanks will be bent out slightly. If the seal is then refitted, sealing and fir ...

Test prerequisites
Radiator and condenser must be clean (clean them if necessary). The heat insulation on expansion valve is OK and properly installed. See vehicle-specific repair manual → Rep. gr.87. The poly V ...