First read and observe the introductory information
and safety warnings
Depending on the vehicle equipment level, the vehicle may have an anti-theft alarm and a SAFELOCK mechanism .
The anti-theft alarm makes it more difficult to break into the vehicle or steal it.
The anti-theft alarm is activated automatically when the vehicle is locked using the vehicle key.
When does the system trigger an alarm?
The anti-theft alarm will sound an acoustic alarm for approximately 30 seconds and trigger a visible warning for up to 5 minutes if any of the following unauthorised actions are performed while the vehicle is locked:
Switching off the alarm
Unlock the vehicle using the release button on the vehicle key or switch on the ignition using a valid vehicle key. In vehicles with Keyless Access, the alarm can be switched off by gripping the door handle .
The alarm will be triggered again if a person gains access to the same or a different secured zone after the alarm has been switched off. For example, if the tailgate is opened after a door had been opened.
The anti-theft alarm will not be activated if the vehicle is
locked from the inside using the central locking button
.
If you unlock the driver door mechanically using the vehicle key, only the driver door is unlocked, and not the whole vehicle. The SAFELOCK mechanism on all doors is not deactivated and the central locking button is not activated until you switch on the ignition (however the doors will not be unlocked).
The anti-theft alarm will not function correctly if the vehicle battery is weak or discharged.
SAFELOCK mechanism
Interior monitoring system and anti-tow alarmSanding
Avoid sanding through to substrate
–
It is recommended to carefully sand the marked area by hand
to avoid “sanding through” the cathodic dip primer.
Seam seals
S ...
Removing and installing oil pressure regulating valve -N428-
Removing
Note
Fit all heat insulation sleeves in the original position
when installing.
–
Remove noise insulation
→ General body repairs, exterior; Rep. gr.66.
...
Checking pistons and cylinder bores
Checking piston
–
Using a micrometre, measure approx. 10 mm from the lower
edge, perpendicular to the piston pin axis.
Maximum deviation from nominal dimension: 0.04 mm
...