Volkswagen Golf Service & Repair Manual: Anti-corrosion wax
| Anti-corrosion wax -AKR 321 M15 4- |
| Anti-corrosion wax -AKR 321 M16 10- |
| Anti-corrosion wax -AKR 321 M15 4- and anti-corrosion wax
-AKR 321 M16 10- are aerosol wax-based rust-protection agents. |
| The film which remains after drying is strongly adhesive,
tough, plastic, water-repellent and nearly colourless. |
| The flow point of the dry substance is over +100 °C, meaning
that running or dripping is unlikely even in the engine
compartment. |
| The dry film adheres well to untreated and painted surfaces. |
| Used for preserving seams, surfaces and cavities of
vehicles. |
| Its light colour makes it especially suitable for protecting
seams on the bonnet and in the boot. |
| The material is also preferred for preserving the cleaned
engine compartment. |
Note
| Before using, read the safety measures and recommendations
in the safety data sheet. |
| Even for products which are not required by law to be
labelled, the usual safety measures for chemical products must
be observed. |
| – |
The parts to be treated with anti-corrosion wax should be
cleaned and dried thoroughly beforehand, and any rust must be
removed. |
| – |
Shake the can well before use. Spray on anti-corrosion wax
and allow it to dry. Do not apply to visible exterior surfaces
because the dry film has a flat appearance. |
Caution
| If engine compartments of vehicles or other
equipment are treated with sealant, the engines should
not be switched on until the protective wax film has
been allowed to dry thoroughly. (Danger of explosion due
to evaporating solvents) |
|
|
|
|
| Colour |
Transparent in thin coat |
| Odour |
Mild odour |
| Viscosity (DIN 53211,
4 mm) |
12-14 seconds |
| Dropping point |
Approx. 100 °C |
| Cleaning |
With mineral spirits,
cold cleaner or kerosene |
| Working temperature |
+15 °C to +30 °C |
Designation:
Cavity-preservative agent -D 330 KD1 A2-
Cavity-preservative agent -D 330 KD2 A1-
Is ...
Other materials:
Introduction
This chapter contains information on the following subjects:
→ Notes on tow-starting
→ Notes on towing
→ Fitting the front towing eye
→ Fitting the rear towing eye
→ Driving notes on towing
Observe any legal requirements when towing or tow-starting.
...
Removing and installing damper element for glove compartment lid
Removing
–
Move glove compartment lid to service position
→ Chapter.
–
Disconnect connector for glove compartment light switch
-E26- on damper element -1-.
– ...
Unlocking the selector lever lock manually
Fig. 214 Removing the cover of the gearshift
gate
Fig. 215 Unlocking the selector lever lock
manually (Variant A) and (Variant B)
First read and observe the introductory information
and safety warningsIf the power fails in the vehicle (for example if the
battery is discharged) and the ve ...
© 2016-2026 Copyright www.vwgolf.org
