Service and disposal of belt tensioners
IntroductionChecking radial and lateral runout of wheels and tyres, tolerances
Radial and lateral run-out occur when the wheel and tyre do
not run absolutely true.
For technical reasons, 100% true running is not possible.
Therefore, the manufacturers of these components allow a
precisely determined ...
Removing and installing left temperature flap control motor -V158-, LHD
vehicles
Special tools and workshop equipment
required
Vehicle diagnostic tester
First carry out the following work:
–
Switch off all electrical consumers.
–
...
Repairs to CAN bus wiring
An unshielded two-wire line -1-
and -2- with a cross section of
0.35 mm2 or 0.5 mm2
is used for CAN bus wiring.
The colour codes of the CAN bus wiring can be gleaned from
the following table:
  ...