Operating and display unitRemoving and installing reversing camera -R189-
Reversing camera and swivel motor are each installed in
individual housings together in swivel badge of rear lid. To
remove camera housing, remove first both components together
with swivel badge from rear lid. Afterwards, camera housing
together with sw ...
Bleeding hydraulic system following standard procedure
Note
Bleeding the hydraulic system using brake filling and
bleeding equipment -VAS 5234- is described.
A pre-pressure of 2 bar is required for bleeding the ABS
hydraulic unit -N55-.
Specia ...
Assembly overview - long noise insulation
Note
The removal and installation procedures may have to be modified
slightly depending on engine fitted.
1 -
Short noise insulation
Removing
–
Remove bolts -2-,
-3- and -4-.
–
Pull out ...