Volkswagen Golf Service & Repair Manual: Adjusting toe on rear axle, multi-link suspension
Special tools and workshop equipment
required |
|
|
|
Torque wrench -V.A.G 1332- |
|
|
|
– |
Turn eccentric bolt -2- until
specification is attained. |
Note
The maximum adjustment range is 90° to the left or right of
centre. |
– |
Check toe value again after tightening nut
-A-
→ Chapter „Specified values for wheel alignment“. |
→ Chapter „Assembly overview - transverse link“ |
|
|
|
Special tools and workshop equipment
required
Torque wrench -V.A.G 1332-
...
Special tools and workshop equipment
required
Torque wrench -V.A.G 1332-
...
Other materials:
Information stored in the control units
First read and observe the introductory information
and safety warnings Your vehicle is factory fitted with electronic control
units which are responsible for engine and gearbox management. The control units
also monitor the function of the exhaust system and the airbags.
These electronic ...
Assembly overview – Blind Spot Monitor (Blind Spot Detection)
1 -
Blind Spot Monitor warning lamp in left exterior mirror -K303-
Removing and installing
→ Chapter
2 -
Blind Spot Monitor warning lamp in right exterior mirror -K304-
Removing and installing
...
Overview of fitting locations – lights in rear doors
1 -
Door warning lamp and entry light
Driver side door warning lamp -W30- and front passenger entry light
-W93-
Front passenger side door warning lamp -W36- and driver side entry
light -W92-
Removing and installing ...
© 2016-2024 Copyright www.vwgolf.org