IntroductionCalibrating Blind Spot Monitor control unit -J1086-/-J1087-
Note
Before the actual calibration process of the control units,
the calibration unit -VAS 6350- needs to be set up as described
in the following chapter.
Special tools and workshop equipment
required
  ...
Run-flat tyres, PAX, checking
When checking a tyre, look out especially for the following
criteria:
Surface erosion or ripples on the inner side (inflation
pressure was too low or not sufficient for the load)
...
Headlight range control, instrument and switch lighting
Fig. 83 Next to steering wheel: headlight
range control
First read and observe the introductory information
and safety warnings Headlight range control
Depending on what level it is set to, the headlight range control adjusts the
position of the light cones in the headlights according ...