Volkswagen Golf Owners Manual: Adjusting the driving mode to suit your requirements
First read and observe the introductory information
and safety warnings
The systems that can be adjusted to your individual requirements depend on the vehicle equipment level.
- Switch on the ignition.
- If necessary, switch on the infotainment system.
- Press the Driving Mode Selection button
and touch
the Individual function button in the infotainment system display.
- Touch the Settings function button to open the Individual menu.
If the checkbox in the function button is ticked 
,
the function is switched on.
Touching the 
function button always takes you
back to the previously active menu.
| Menu | Submenu | Settings options |
|---|---|---|
| Individual | DCC: | Comfort |
| Normal | ||
| Sport | ||
| Steering: | Normal | |
| Sport | ||
| Engine: | Normal | |
| Sport | ||
| Eco | ||
| ACC: | Normal | |
| Sport | ||
| Eco | ||
| Bend lighting: | Normal | |
| Sport | ||
| Eco | ||
| Air conditioning: | Normal | |
| Eco | ||
| Reset mode: | Settings are reset to Normal. |
Changes to settings menus are applied immediately, with the exception of engine settings.
WARNING
Function and operation
Fig. 180 In the lower section of the centre
console: Driving Mode Selection button
First read and observe the introductory information
and safety warnings The driver can choose from up to 5 di ...
Other materials:
Introduction
This chapter contains information on the following subjects:
→ General information
→ Parking
A camera in the tailgate helps the driver when reversing or manoeuvring the vehicle.
The camera picture and the orientation lines projected by the system are displayed
on the ...
Renewing rear bonded rubber bush
Special tools and workshop equipment required
Tensioning strap -T10038-
Assembly tool -T10263-
Assembly tool -T10356-
Engine and gearbox jack -V.A.G 1383 A-
Hydraulic press -VAS 6178- and thrust piece - ...
Overview - drive shaft
I -
→ Chapter „Assembly overview - drive shaft, constant velocity joint
VL100“
II -
→ Chapter „Assembly overview - drive shaft, constant velocity joint
VL107“
III -
→ Cha ...
