Volkswagen Golf Service & Repair Manual: Adjusting striker pin

Volkswagen Golf Service & Repair Manual / General body repairs, exterior / Rear door, sliding door, wing doors, central locking / Door / Adjusting striker pin

Special tools and workshop equipment required

Torque wrench -V.A.G 1331-

Socket -3410-

Note

Threaded plate -1- of striker pin is secured in pillar using a method which differs from the previous method.

Bow outside of threaded plate is welded firmly to pillar. Webs to threaded plate are plastically deformable.

Substantial force must be applied so that striker pin -2- can be adjusted with bolts -3- loosened.

Adjusting striker pin

Note

Only the adjustment for the left front door is described. The adjustment of the right front door is similar.

The rear door must lock fully when closing without any additional force being required and must not have any play.

The rear door must not be pushed up or down as a result of the striker pin adjustment.

Striker pin can be used to align rear door flush with side panel (to prevent wind noise) -arrows-.

–	Loosen striker -2- by loosening bolts -3- in C-pillar.

Note

Substantial force must be applied so that striker pin -2- can be adjusted with bolts -3- loosened.

–	Tighten bolts -23- of striker pin -2-.

	Component	Specified torques
Striker pin	20 Nm

Adjusting door

Special tools and workshop equipment required Door alignment tool -3320- Universal joint for 3320 -3 ...

Removing and installing door arrester

Special tools and workshop equipment required Note Removal and installation are only described ...

Other materials:

Warning and indicator lamps
First read and observe the introductory information and safety warnings Lit up Possible cause Solution Gearbox fault. Do not drive on! Move the selector lever to position P and leave the gearbox to cool down. If ...

Removing and installing rain and light sensor, vehicles without front camera for driver assist systems
Note The rain and light sensor has a silicon layer (coupling pad) which forms the contact surface to the windscreen. The rain and light sensor has been designed so that it can be used again. A prerequisite for re-use ...

Removing and installing luggage compartment light -W3-
Removing Caution Danger of damage to component surfaces. When using leverage tools, mask visible areas of the component with commercially available adhesive tape. ...