Volkswagen Golf Service & Repair Manual: Adjusting glass panel
| Special tools and workshop equipment
required |
|
|
|
| Height-adjustment of glass panel |
|
|
Torque wrench -V.A.G 1783- |
| – |
Loosen securing bolts for glass panel. |
| – |
Operate glass panel of panorama tilting roof so that it moves to
“open” position. |
| – |
Operate glass panel of panorama tilting roof so that it moves to
“closed” position. |
| – |
Adjust height of glass panel at front and rear on both sides as
follows: |
| -Dimension a- = 1 mm lower than roof
assembly frame -3-. |
| – |
Press the inner seal to one side. |
| – |
Tighten the front inside bolts. |
| -Dimension b- = 1 mm above roof profile
-2- |
| – |
Tighten the rear inside bolts. |
| – |
Open glass panel and tighten the rear bolts. |
Note
| |
To achieve the best possible optical appearance, ensure that
adjustments on left and right are uniform (symmetrical). |
| |
The glass panel should not be higher than the roof at any point
at the front or lower than the roof at any point at the rear. |
Special tools and workshop equipment
required
Removing
Torque wre ...
Special tools and workshop equipment
required
Removing
Torque wre ...
Other materials:
2-pack wash primer
Designation:
2-pack wash primer -LLS MAX 230 M1-, olive-green (250 ml)
Issued 12.2013
Product description
The 2-pack wash primer -LLS MAX 230 M1- is a zinc
chromate-free ...
Removing and installing turbocharger
Special tools and workshop equipment
required
Engine bung set -VAS 6122-
Hose clip pliers -VAS 6362-
...
Introduction
This chapter contains information on the following subjects:
→ Warning lamp
→ Checking the electrolyte level of the vehicle battery
→ Charging, replacing, disconnecting and connecting the vehicle battery
The vehicle battery is a component of the electrical ...
© 2016-2026 Copyright www.vwgolf.org
Removing and installing wind deflector
Removing and installing guide plate