Volkswagen Golf Service & Repair Manual: Adjusting front axle toe
| Special tools and workshop equipment
required |
|
|
|
| Torque wrench -V.A.G 1332- |
|
|
|
| – |
Counterhold track rod ball joint -1-
with a suitable tool when loosening and tightening lock nut
-2-. |
| – |
Adjust toe setting at both wheels by turning hexagon flats
-arrow-. |
 Note
| Ensure that bellows on steering rack are not damaged or
twisted. Twisted boots wear out quickly. |
| Tighten lock nuts on threaded portion only when vehicle is
standing on its wheels - track rod ball head must be parallel
with steering lever of suspension strut. |
| – |
Tighten lock nut -2- and check
toe setting again. |
| The setting may change slightly after lock nut
-2- is tightened . |
| However, if the measured toe value lies within the
tolerance, the adjustment is correct
→ Chapter „Specified values for wheel alignment“. |
| → Chapter „Repairing steering rack“ |
|
|
|
Special tools and workshop equipment
required
Torque wrench -V.A.G 1332-
...
If run-out compensation is not performed, it is not possible
to adjust toe-in correctly!
The existing lateral run-out of the wheel must be
comp ...
© 2016-2024 Copyright www.vwgolf.org
Adjusting toe on rear axle, multi-link suspension
Wheel runout compensation