Volkswagen Golf Service & Repair Manual: Adjusting Bowden cable A for entry assistance
Special tools and workshop equipment
required |
|
Feeler gauges -VAS 5301/10- |
-
|
Seat pan and backrest must be padded and bolted
together. |
-
|
Adjustment knob of backrest adjustment is turned towards
front as far as stop. |
-
|
Bowden cable B must be attached to seat longitudinal
adjustment and to fitting on backrest. |
-
|
Adjustment must be carried out exclusively on inner side
of seat (tunnel side). |
|
|
|
– |
Adjust seat rail so that one locking pin
-1- protrudes. |
Note
It does not matter which of the locking pins protrudes. |
|
|
|
– |
Push lever -1- on backrest
fitting in -direction of arrow- as
far as stop. |
Note
For reasons of clarity, the padding and cover are not shown
in illustration. |
|
|
|
– |
Using a feeler gauge, measure distance between tabs
-arrows- of release plate
-1- and plate
-2-. |
|
The 0.1 mm feeler gauge must fit underneath all tabs
-arrows- of release plate. |
|
The 0.3 mm feeler gauge must not fit underneath at least one
tab. |
If the setting is incorrect, proceed as follows: |
|
|
|
– |
Release Bowden cable adjuster. To do this, hold the upper
part -1- using pliers and turn
locking sleeve -2- approx. 45° in
-direction of arrow A-. |
– |
To release locking sleeve, press it down as far as stop
-arrow B-. |
|
The lower part -3- must be free
to turn. |
– |
Turn lower part and upper part in opposite directions in
order to adjust Bowden cable. |
|
|
|
– |
Adjust Bowden cable in such a way that release plate
-1- is just about to be lifted off
plate -2-. |
|
The 0.1 mm feeler gauge must fit underneath all tabs
-arrows- of release plate. |
|
The 0.3 mm feeler gauge must not fit underneath at least one
tab. |
– |
Perform functional check of Bowden cables after adjusting. |
– |
Check routing of Bowden cable or readjust Bowden cable if
locking mechanism does not release or only partially releases. |
– |
Lock Bowden cable adjuster upon completion. |
|
|
|
Removing
–
Remove front seat
→ Chapter.
–
Secure front seat on seat repair stand
...
Removing
–
Remove front seat
→ Chapter.
–
Secure front seat on seat repair stand
...
Other materials:
Removing and installing high-pressure pump
Removing
Engine cold
The fuel system is under high pressure.Risk of injury due to fuel which
may spurt out.Release high pressure.
→ Chapter
Risk of functional impairment due to soiling
...
Corrosion protection for body components, add-on components and welded
components
Attachments
Wings, doors, covers and flaps must be coated completely on
the inside as well. One wet-in-wet spray pass is adequate for
this.
Before installing, add-on parts must be sealed with cav ...
Wheel bolts, versions
Explanations regarding types of convex seats
There are two different versions of convex tapered seats,
the spherical seat and the tapered.
The spherical seat is the curved surface of a s ...
© 2016-2024 Copyright www.vwgolf.org