Volkswagen Golf Service & Repair Manual: 1-pack wash primer
| |
1-pack wash primer -LVM 044 007 A2-, light grey |
| |
1-pack wash primer -LVM 044 171 A2-, dark grey |
| The 1-pack wash primer is a zinc chromate-free single-pack
product suitable for all commonly found metallic substrates. |
| |
Suitable for all common metallic substrates |
| |
VOC compliant with good corrosion protection |
| |
Easy-to-use one-pack product |
| |
Available in light grey and dark grey |
| |
Cleaned and sanded electroplated or roller-galvanised steel
panels or soft aluminium |
| |
Lightly sanded factory primer (not for large surfaces of
lightly sanded electrophoretic primer of new parts) |
| |
Well-sanded factory paint or old paint (with the exception
of thermoplastic paint) |
| |
Surfaces prepared with 2-pack polyester products and then
finely sanded |
 Note
| Owing to the wide variety of metal alloys and manufacturing
processes, it is essential to carry out a preliminary test on
the respective substrate to ensure that the pretreatment is
sufficient to guarantee perfect adhesion. |
|
|
|
| – |
Thoroughly clean with silicone remover -LVM 020 000 A5- or
slow-drying silicone remover -LVM 020 100 A5-. |
|
|
|
| – |
Clean and lightly sand factory paint or old paint,
completely remove any rust spots and sand feather edges to the
old paint. |
|
|
|
| – |
Before recoating, use a suitable cleaning agent to ensure a
clean surface free of residues. |
|
|
|
| |
2-pack thinner -LVE 009 001 A5- |
| |
2-pack thinner plus -LHA 014 000 A5- |
| |
2-pack thinner, special -LVM 009 200 A2/A5- |
| |
2-pack thinner, slow-drying -LVM 009 300 A2- (for large
objects and high temperatures) |
| Method of application: “spray”. |
|
|
|
| – |
Application viscosity 4 mm, at +20°C, DIN 53211 is the
mixing viscosity. |
| Add 50% thinner at a material temperature of +20 °C |
|
|
|
| – |
If thinner is added, use measuring stick to mix. |
| Application viscosity 4 mm, gravity-feed spray gun
“compliant” and “HVLP”: |
|
|
|
| – |
Adjust spray nozzle following manufacturer's instructions to
1.3-1.5 mm for “compliancy” and “HVLP”. |
| – |
Adjust spray pressure following manufacturer's instructions
to 2.0-2.5 bar for “compliancy”. |
|
|
|
| – |
When using as wash primer, apply one spray coat. |
| – |
The specified thickness for the dry film is 10-15 µm. |
Note
| Small bare-metal spots may be isolated using waterborne base
coat or 2-pack HS top coat only with wet-on-wet application or
with intermediate sanding on top of 1-pack wash primer -LVM 044
007 A2-/-LVM 044 171 A2- if the bare-metal spot is not greater
than 5.0 cm in diameter. |
|
|
|
| Flash-off time at +20 °C ambient temperature, recoat after: |
| |
10-15 minutes with 2-pack HS surfacer. |
| |
20-30 minutes with waterborne base coat (only for small
bare-metal spots) |
| |
10-15 minutes with 2-pack HS top coat (only for small
bare-metal spots) |
| |
Dry for sanding in 45-60 minutes |
|
|
|
|
Application |
Recoat with |
| As wash primer |
2-pack HS surfacer |
| as wash primer with
intermediate sanding |
Wet sand with P800 to
P1000-grade paper |
| |
Waterborne base coat and 2-pack HS clear coat (only for
small bare-metal spots). |
| |
2-pack HS top coat (only for small bare-metal spots). |
Caution
| Do not recoat with polyester products. |
| Do not use on thermoplastic paint. |
| Do not recoat with epoxy products. |
| Do not recoat with water-based products. |
|
|
|
|
| Personal protective equipment: |
| |
Adhere to the safety data sheet. |
| |
Wear personal protective equipment during application. |
|
|
|
| Viscosity as supplied |
At least 60 seconds |
| Flash point: |
Above +23 °C |
| VOC content:
2004/42/IIB(c)(780)760 |
The EU limit value for this
product (product category IIB.c) in ready-to-spray form is max.
780 g/litre of volatile organic compounds. The VOC content of this
product in ready-to-spray form is max. 760 g/l. |
| The guaranteed shelf life is 24 months from date of
production. May be used until the date stated on the label at
latest if stored in sealed original containers at +20 °C. |
|
|
|
Designation:
1-pack anti-corrosion wash primer -ALN 002 003 10-
Issued 06/2011
Product descripti ...
Designation:
2-pack wash primer -LHV 043 000 A2-
Issued 10.2010
Product description
...
© 2016-2024 Copyright www.vwgolf.org
1-pack anti-corrosion wash primer
2-pack wash primer