Model X has a unique horizontal face-level vent that spans the width of the dashboard. It also has vents at the top and bottom of the rear console.
Using the touchscreens, you can pinpoint exactly where you want to direct the air flowing from this vent when heating or cooling the cabin. When the face-level vent is on you can adjust the direction of the air flow from each vent. To adjust the direction of the air flow, touch the radiating air waves from the corresponding vent on the touchscreen. The air flows in a single stream when centered or splits into mirrored air streams when air is directed outward or inward from the center of the vent.
NOTE: When you split a vent into two separate air flows, the air flow in each direction is not as strong as when all air is flowing in a single direction.
NOTE: Outside air is drawn into Model X through the grill in front of the windshield. Keep the grill clear of obstructions, such as leaves and snow.
Charging totally discharged batteries with battery charger -VAS 5900-
WARNING
Danger of injury! Observe warning notices and safety
regulations
→ Chapter!
WARNING
It is not permissible ...
Connecting brake lines to hydraulic unit, RHD vehicles
On hydraulic unit:
1 -
From hydraulic unit to rear left brake caliper.
-
Identification: Ш 5.25 mm and flare nut with thread M 10 x 1
2 -
From hydraulic u ...
Removing and installing bumper cover
Volkswagen R GmbH, optional equipment, “R Line” and “R”
Note
The removal and installation procedures for the bumper cover
may vary slightly, depending on vehicle model.
Spec ...