Volkswagen Golf Owners Manual: Switching over headlights for driving abroad (travel mode)
First read and observe the introductory information
and safety warnings
If you have to drive a right-hand drive vehicle in a left-hand drive country, or vice versa, the asymmetric dipped beam headlights may dazzle oncoming traffic with xenon headlights. Therefore, the headlights must be switched over if you are driving abroad.
The headlight orientation can be adjusted using the
button and the 
and
Light function buttons in the infotainment system .
A qualified workshop can provide you with further information. Volkswagen recommends using a Volkswagen dealership for this purpose.
Using travel mode is only reliable, if used for a short period. Please contact a qualified workshop for a permanent alteration. Volkswagen recommends using a Volkswagen dealership for this purpose.
The function of the dynamic bend lighting and automatic main beam assist is deactivated once the travel mode is activated , .
Main beam assist
First read and observe the introductory information
and safety warnings Main beam assist (Light Assist)
Within the limits of the system, the main beam assist automatically switches
the main be ...
Coming Home and Leaving Home functions (orientation lighting)
First read and observe the introductory information
and safety warnings The Coming Home function is switched on manually. However,
the Leaving Home function is controlled automatically by a twil ...
Other materials:
Gaskets, seals
After removing gaskets and seals, always inspect contact
surface of housing or shaft for burrs resulting from removal or
for other signs of damage.
Before installing seals, lightly oil outer diameter and
half-fill space between sea ...
Repairs to CAN bus wiring
An unshielded two-wire line -1-
and -2- with a cross section of
0.35 mm2 or 0.5 mm2
is used for CAN bus wiring.
The colour codes of the CAN bus wiring can be gleaned from
the following table:
...
Assembly overview - sealing flange, belt pulley end
1 -
Bolt
Risk of damage to engine caused by incorrect valve timing.Do not turn crankshaft
out of TDC position.
Specified torque
→ Item
2 -
Vibration damper
Removing and installing
→&nb ...