VW Golf manuals

Volkswagen Golf Service & Repair Manual: Stone chip tester -VAS 5102A

Designation:
Stone chip tester -VAS 5102A-
Product description
The stone chip tester -VAS 5102A- has been developed by VW AG and allows the user to recognise whether paint damage is the result of a fault in material or application or whether it has been caused by excessive mechanical stress, for example stone chipping or scratching. The test is based on the simulation of average impact on vehicle paintwork in road traffic of low-mass bodies, e.g. sand or gravel, travelling at a high velocity.
  Note
The testing procedure is described in detail in the catalogue "Assessment of Vehicle Paintwork".
The unit is subject to an annual inspection by the manufacturer. A charge will be levied for this service.
Items supplied:
1 stone chip tester with battery-powered metering device, pressure regulator and hose
1 mains connector
Calibration stand with test scales
Illuminated magnifier
Film with angles marked
Adhesive tape, 25 mm wide
Filling knife and scissors
Granulate feeder with 10 x 100 g granulate
Hard case with rollers
100 each VW and Audi seals
Operating instructions, evaluation scale, test certificate, test plan
 

Stone chip tester -VAS 5102A

Paint thickness tester -VAS 5278
Designation: Paint thickness tester -VAS 5278- Product description The paint thickness tester allows pr ...

Pneumatic brush grinder set -VAS 6446
Designation: Pneumatic brush grinder set -VAS 6446- Product description: The pneumatic brush grinder se ...

Other materials:

ParkPilot menu
First read and observe the introductory information and safety warnings ParkPilot settings in the infotainment system menu Switch on the ignition. If necessary, switch on the infotainment system. Press the  button. Touch the function button. Touch the Parking and manoeuvering fu ...

Renewing pyrotechnic, electrical and mechanical components of the restraint system after an accident
Special tools and workshop equipment required   Vehicle diagnostic tester   Note   The airbag control unit can be used for up to 2 side airbag and/or belt tensioner deploym ...

Calibrating Blind Spot Monitor control unit -J1086-/-J1087-
  Note Before the actual calibration process of the control units, the calibration unit -VAS 6350- needs to be set up as described in the following chapter. Special tools and workshop equipment required   ...

© 2016-2020 Copyright www.vwgolf.org