VW Golf manuals

Volkswagen Golf Service & Repair Manual: Safety precautions when working on vehicles with a Start/Stop system

Volkswagen Golf Service & Repair Manual / 7- speed dual clutch gearbox 0CW / Technical data / Safety instructions / Safety precautions when working on vehicles with a Start/Stop system

During work on vehicles with Start/Stop system, observe the following:
  WARNING
Injury hazard as a result of automatic engine start in vehicles with Start/Stop system
In vehicles with the Start/Stop system activated (identifiable by an indication in the dash panel insert) the engine can start automatically if required.
When working on the vehicle, always make sure that the Start/Stop system is deactivated (switch off the ignition; switch the ignition on again if necessary).
General safety regulations
To prevent personal injury and material damage to the vehicle, observe the following:   WARNING Risk of ...

Safety precautions when using test and measuring equipment during a road test
Observe the following if test and measuring equipment is required during a road test:   WARNING Acciden ...

Other materials:

Removing and installing speed sensor on rear axle -G44-/-G46-, vehicles with front-wheel drive
  Note Removal and installation is described for the rear left speed sensor. Removal and installation of the rear right speed sensor is analogous.     Rear left speed sensor -G46--1-: ...

Assembly overview - rear parking aid, RHD vehicles
1 -  Electrical connector 2 -  Spreader clip 3 -  Rear parking aid warning buzzer -H15- Removing and installing → Chapter 4 -  Spreader clip 5 -&n ...

Removing and installing high-voltage heater (PTC) -Z115- / high-voltage heater (PTC) -J848
Special tools and workshop equipment required Commercially available Torx socket bit “TS30H” with hole in front face Hose clamps, up to 25 mm -3094- Engine bung set -VAS 6122- ...

© 2016-2019 Copyright www.vwgolf.org