Volkswagen Golf Service & Repair Manual: Removing and installing TV tuner, eGolf
Special tools and workshop equipment
required |
|
|
|
Protective cap for wiring harness connector -VAS 6223/9- |
If the control unit is replaced, select the
Replace function of the respective
control unit in Guided fault finding
→ Vehicle diagnostic tester. |
– |
Remove luggage compartment floor |
|
|
|
– |
Release strap -1- and
disconnect connectors -2-. |
|
|
|
– |
Push protective cap for cable connector -VAS 6223/9--1-
onto connector of MOST bus -2-. |
– |
Remove TV tuner -R171-. |
Install in the reverse order of removal. When doing this,
note the following: |
|
|
|
Special tools and workshop equipment
required
Protective cap for wiring harness connector -VAS 6223/9-
...
Other materials:
Removing and installing thermostat for large cooling circuit
Special tools and workshop equipment
required
Hose clip pliers -VAS 6362-
Special wrench -T10508-
R ...
Assembly overview - drive shaft
1 -
Outer constant velocity joint
Renew only as complete unit
Removing
→ Fig..
Installing: drive onto shaft to stop using plastic hammer
Distribute grease evenly in joint
Ch ...
Gaskets, seals
After removing gaskets and seals, always inspect contact
surface of housing or shaft for burrs resulting from removal or
for other signs of damage.
Before installing seals, lightly oil outer diameter and
half-fill space between sea ...
© 2016-2024 Copyright www.vwgolf.org