Volkswagen Golf Service & Repair Manual: Removing and installing rear 3-point seat belt, 4-door model, without belt tensioner

Volkswagen Golf Service & Repair Manual / General body repairs, interior / Pasanger protection / Seat belts / Removing and installing rear 3-point seat belt, 4-door model, without belt tensioner

Removing

–	Remove rear shelf support → Chapter.

–	Remove outer rear seat belt guide anchor → Chapter.

–	Remove bolt -1-.

–	Remove belt inertia reel -2- from mounting.

Installing

Install in reverse order, but note the following:

–	If parts of the belt system are removed because of an accident, the belt system bolts must be renewed.

Specified torques

→ Chapter „Assembly overview - three-point seat belt, 4-door model, without belt tensioner“

Removing and installing rear 3-point seat belt, 4-door model, without belt tensioner

Removing and installing rear 3-point seat belt, 2-door model, with belt tensioner

Removing WARNING Observe safety instructions for pyrotechnic components U ...

Removing and installing rear 3-point seat belt, 4-door model, with belt tensioner

Removing WARNING Observe safety instructions for pyrotechnic components U ...

Other materials:

Before operating the air conditioning system after recharging with refrigerant
After installing a new air conditioner compressor or filling with fresh refrigerant oil (e.g. after blowing out refrigerant circuit), turn compressor pulley 10 revolutions by hand before starting engine. This will prevent damage to the air conditioner ...

Assembly overview - drive shaft, constant velocity joint VL100
1 - Outer constant velocity joint Renew only as complete unit Removing → Anchor. Installing: drive onto shaft to stop using plastic hammer Checking → Chapter 2&nb ...

Checking fuel delivery rate, vehicles with four-wheel drive
Special tools and workshop equipment required Removal wedge -3409- Remote control for V.A.G. 1348 -V.A.G 1348/3A- Multimeter e.g. hand-held multimeter -V.A.G 1526E- Test instrument adapter/DSO (5-pin) -VAS 5565- ...