Volkswagen Golf Service & Repair Manual: Rear seat covers and padding
- Assembly overview - cover and padding for bench seat
- Assembly overview - rear seat backrest cover and padding
- Removing and installing bench seat cover and padding
- Removing and installing rear seat backrest cover and padding
- Removing and installing intermediate padding, backrest with through-loading aperture
- Separating cover and padding for rear bench seat
- Separating cover and padding for rear seat backrest
Removing and installing backrest heating element -Z7-/-Z9-
Removing
If the backrest padding in a vehicle with seat heating is
renewed, then the respective backrest heating element must also
be renewed.
...
Assembly overview - cover and padding for bench seat
1 -
Seat frame
2 -
Seat padding
Allocation
→ Electronic Parts Catalogue
Removing and installing seat cover and seat paddi ...
Other materials:
Overview of fitting locations - storage compartments/covers
1 -
Dash panel
Assembly overview
→ Chapter
2 -
Glove compartment
Assembly overview
→ Chapter
3 -
Centre console
Assembly overview
→ Chapter
4 ...
Checking adjustment of assembly mountings (engine and gearbox mountings)
Procedure
The following specifications must be obtained:
There must be a distance of -a-
= 10 mm between engine support -2-
and engine mounting -1-.
...
Removing and installing refrigerant shut-off valve for high-voltage battery
heat exchanger -N542
Removing
–
Observe safety precautions
→ Chapter „Safety precautions when handling refrigerants“.
–
Comply with notes
→ Chapter „Working on refrigerant circuit“.
...