First read and observe the introductory information
and safety warnings
For reasons of vehicle registration and vehicle taxation, the power output and performance of some engines may vary in some countries from the information given in this booklet.
Petrol engines
Engine power | EC | Gearbox type | Maximum speed |
---|---|---|---|
63 kW BlueMotion technology | CJZB | MG5 | 179 km/h |
77 kW BlueMotion technology | CJZA | MG5 | 192 km/h |
MG6 | 192 km/ha) | ||
DSG®7 | 192 km/h | ||
90 kW BlueMotion technology | CMBA | MG6 | 203 km/ha) |
DSG®7 | 203 km/h | ||
103 kW BlueMotion Technology, without active cylinder managementb) |
CHPA | MG6 | 212 km/ha) |
DSG®7 | 212 km/h | ||
103 kW BlueMotion Technology, with active cylinder management |
CPTA | MG6 | 212 km/ha) |
DSG®7 | 212 km/h |
Diesel engines
Engine power | EC | Gearbox type | Maximum speed |
---|---|---|---|
77 kW BlueMotion technology with DPF | CLHA | MG5 | 192 km/h |
DSG®7 | 192 km/h | ||
MG6 4MOTION | 186 km/h | ||
110 kW BlueMotion technology with DPF | CRBC | MG6 | 216 km/h |
DSG®6 | 212 km/h | ||
MG6 4MOTION | 210 km/h |
E85 MultiFuel engine
Engine power | EC | Gearbox type | Maximum speed |
---|---|---|---|
90 kW BlueMotion technology | CPVA | MG6 | 203 km/hc) |
In certain vehicles with heavy duty suspension, the engine could be governed to provide a maximum speed of 210 km/h.
The performance figures were measured without equipment which may influence performance, such as a roof carrier or mud flaps.
a) Maximum speed is reached in 5th gear.
b) The figures shown may vary for vehicles compliant with EU2 or EU4 exhaust emission standards.
c) Maximum speed is reached in 5th gear.
Fuse tables for fuses in the engine compartment
Fig. 231 Engine compartment: fuse layout
First read and observe the introductory information
and safety warningsThe table shows the fuse locations for the items of electrical
equipment which are most relevant to the customer. The left column contains the
location, the other columns contain ...
Eliminating flat spots caused by storage or handling
Eliminating flat spots caused by storage or handling
Flat spots caused by storage or handling cannot be
eliminated from the tyre using workshop equipment.
Flat spots caused by storage or handling can be removed onl ...
Checking belt guide fittings and latch plates
Plastic-coated fittings show fine, parallel scoring after
stress on belt system (when belt was fastened during accident).
(On the other hand, wear caused by frequent belt use can be
recognized by smooth wear, free of lines.)
–
...