VW Golf manuals

Volkswagen Golf Service & Repair Manual: Nuts and bolts

Loosen and tighten bolts and securing nuts for covers and housings diagonally.
Avoid canting particularly sensitive parts such as comtrol motor with control unit. Loosen and tighten them diagonally in stages.
Specified torques given are for unlubricated nuts, bolts and screws.
Always renew self-locking nuts and bolts.
 

Nuts and bolts

Steering rack
To achieve the desired results when performing repairs on the steering rack it is important to work with the greatest possible care and cleanliness, and to use proper ...

Electrical components
At some point, you have probably received an electric shock when touching a metal object. This is due to the electrostatic charge accumulated by the human body. This ...

Other materials:

Assembly overview - FS III front brake
  Note After every brake pad change, depress brake pedal firmly several times with vehicle stationary, so that brake pads are properly seated in their normal operating position. Use the brake filling and bleeding equipment -VAS 5234- to draw off brake ...

Removing and installing air recirculation flap control motor -V113-, LHD vehicles
Heater and air conditioning system with electric/manual controls Special tools and workshop equipment required Vehicle diagnostic tester   Note The control motor has end stops wi ...

On a regulated roller dynamometer with contra-rotating rollers for four-wheel drive vehicles
  Note The brake test must be performed on a controlled contra-rotating single-axle roller dynamometer for four-wheel drive vehicles. “Contra-rotating” means that the dynamometer rollers of the single-axle roller dynamom ...

© 2016-2020 Copyright www.vwgolf.org