Volkswagen Golf Service & Repair Manual: Notes on repairs to contact housings and connectors
Note
Observe the general notes on repairs to the vehicle
electrical system
→ Chapter. |
Allocation of the appropriate crimp contacts to the contact
housings is by way of the part number stamped on the contact
housing. Listed in illustration 198 (electrical connecting
elements) in
→ Electronic parts catalogue (ETKA) are the part
numbers for the contact housings in conjunction with the
associated crimp contacts. |
Damaged contact housings must always be replaced. |
New contact housings can be ordered from the OTC in Kassel. |
|
Checking the aerial wire:
→ Anchor
Changing tool adapter:
→ Anchor
Cutting aerial wire:
U ...
If necessary, first open or disengage the secondary locking
mechanism of the contact housing
→ Chapter.
...
Other materials:
Removing and installing front tunnel cross-piece
Special tools and workshop equipment
required
Torque wrench -V.A.G 1331-
Removing
–
If fitted, remove centre underbody panel
→ ...
Removing and installing brake pads or linings
Special tools and workshop equipment required
Vehicle diagnosis, testing and information system -VAS 5051-
Tool set for brake bleeding -VAS 6564-
Insert tool with ratchet -VAS 6784-
Bit attachment (7 mm) -T10503-
...
Introduction
This chapter contains information on the following subjects:
→ Sockets in the vehicle
Electrical equipment can be connected to the sockets in the vehicle.
The devices connected must be in good condition and fault-free.
Additional information and warnings:
Cigarette lighter
...
© 2016-2021 Copyright www.vwgolf.org