This chapter contains information on the following subjects:
→ General information on transporting children in the vehicle
→ Various securing systems→ Using a child seat on the front passenger seat
→ Using a child seat on the rear seats→ Securing child seats with a seat belt
→ Securing child seats using lower anchoring points (ISOFIX, LATCH)→ Securing child seats with the top tether
It is imperative that you read all of the information concerning the airbag system before transporting babies or children in a child seat on the front passenger seat.
This information is very important for the safety of the driver and the safety of all passengers, babies and small children in particular.
Volkswagen recommends using child seats from Volkswagen's range of accessories. These child seats were developed and approved for use in Volkswagen vehicles. Child seats for the various different securing systems are available from a Volkswagen dealership.
Additional information and warnings:
WARNING
Children who are not strapped in or who are not strapped in properly could sustain severe or fatal injuries while the vehicle is in motion.WARNING
An unsecured, unoccupied child seat could be flung through the vehicle interior in the event of a sudden braking manoeuvre or accident. This could cause injuries.Replace child seats that withstand any force during an accident as they could have sustained damage that may not be visible.
Assembly overview - poly V-belt drive, vehicles with air conditioner
compressor
1 -
Poly V-belt
Check for wear
Before removing, mark direction of rotation with chalk or
felt-tipped pen.
Do not kink
The length of the poly V-belt must be determined according to the
→ E ...
Removing and installing storage compartment
Special tools and workshop equipment
required
Torque wrench -V.A.G 1783-
Removing
–
Unbolt front seat and tilt it towards rear. Do not remove
...
Assembly overview - brake pedal, RHD vehicles
Note
The handbrake pedal travel must not be restricted by additional
floor coverings.
Do not lubricate or grease the pivot pin. The pivot pin must remain
dry.
1 -
Bolt
20 Nm
2 -
...