Volkswagen Golf Service & Repair Manual: General notes
- Starting conditions for auxiliary heater, auxiliary heater mode
- Starting conditions for auxiliary heater, supplementary heater mode
- Notes for vehicles with start-stop system
- Rules for cleanliness for working on the auxiliary heater and the fuel system
- Identification plates
- General repair instructions
Safety precautions when working in the vicinity of high-voltage components
Danger to life due to high voltage
The high-voltage system is under high voltage. If high-voltage
components are damaged, there is a risk of severe or fatal injury due to
e ...
Starting conditions for auxiliary heater, auxiliary heater mode
Auxiliary heater coded in Gateway
Reserve fuel level not reached
No crash shut-off
...
Other materials:
Removing and installing footwell vent temperature sender -G192
Special tools and workshop equipment
required
Removal wedge -3409-
Vehicle diagnostic tester
Removing
Note
Only o ...
Bleeding hydraulic system following standard procedure
Note
Bleeding the hydraulic system using brake filling and
bleeding equipment -VAS 5234- is described.
A pre-pressure of 2 bar is required for bleeding the ABS
hydraulic unit -N55-.
Specia ...
Run-flat tyres, retrofitting/requirements when using run-flat tyres
Caution
Retrofitting run-flat tyres to vehicles may only be
undertaken if the tyres are fitted as standard or they
are available as an option.
These tyres may only be used ...