Checking pistons and cylinder bores
Checking piston
–
Using a micrometre, measure approx. 10 mm from the lower
edge, perpendicular to the piston pin axis.
Maximum deviation from nominal dimension: 0.04 mm
...
Lowering rear axle, multi-link suspension, four-wheel drive
Special tools and workshop equipment
required
Torque wrench -V.A.G 1332-
Engine and gearbox jack -V.A.G 1383 A-
...
Removing and installing B-pillar trim on rear door
Note
Removal and installation are described only for the left side.
Removal and installation of the right side are similar.
Removing
–
Run door window down to bottom position.
–
Pull window channel -3- in area ...