Volkswagen Golf Owners Manual: Consumer information
- Introduction
- Information stickers and plates
- Using the vehicle in other countries and continents
- Radio reception and aerials
- Component protection
- Volkswagen repair information
- Declaration of conformity
- Recycling and scrapping end-of-life vehicles
- Declaration of conformity for wheels and tyres
Rodent proofing
First read and observe the introductory information
and safety warnings Rodent proofing equipment is made up of special brushes
and casings and impedes entry to the engine compartment by rodents ...
Introduction
This chapter contains information on the following subjects:
→ Information stickers and plates  
→ Using the vehicle in other countries and continents  
→ Radio recepti ...
Other materials:
Removing and installing engine control unit -J623- (with metal locking
plate)
Special tools and workshop equipment
required
Hot air blower -VAS 1978/14A--1-
with nozzle -2- from wiring harness
repair set -VAS 1978 B-
Small grinder (commerci ...
Removing and installing onboard supply control unit -J519-, LHD vehicles
Note
When renewing the control unit, select
Renew function for the respective control unit in
Guided fault finding or
Guided functions mode
→ Vehicle
diagnostic tester.
Removing
â ...
Removing and installing refrigerant line between air conditioner compressor
and evaporator
Special tools and workshop equipment
required
Engine bung set -VAS 6122
Torque wrench -V.A.G 1331/- (5…50 Nm)
...