Checking belt guide fittings and latch plates
Plastic-coated fittings show fine, parallel scoring after
stress on belt system (when belt was fastened during accident).
(On the other hand, wear caused by frequent belt use can be
recognized by smooth wear, free of lines.)
–
...
Removing and installing Denso heat exchanger, LHD vehicles
Special tools and workshop equipment
required
Drip tray for workshop hoist -VAS 6208-
Hose clamps up to 25 mm -3094-
...
Balancing wheel, balancing wheel on stationary wheel balancer
Before you start balancing the wheels, the following
requirements must be met.
Tyre pressure must be OK.
Tread must not be worn on one side. Tread depth should be at
least 4 mm.
T ...