Volkswagen Golf Service & Repair Manual: Battery
 Note
|
Note
|
Routing and securing wiring
Mark lines prior to removal to prevent them from being
interchanged and to ensure that they are fitted in their
original positions. This applies for fuel, hydraulic a ...
Other materials:
Removing and installing high-voltage heater (PTC) -Z115- / high-voltage
heater (PTC) -J848
Special tools and workshop equipment
required
Commercially available Torx socket bit “TS30H” with hole in
front face
Hose clamps, up to 25 mm -3094-
Engine bung set -VAS 6122- ...
Safety precautions for working on vehicles with Start/Stop system
Risk of injury due to unexpected engine start
In vehicles with activated Start/Stop system, the engine may start
up unexpectedly. The status of the Start/Stop system is indicated by a
message in the dash panel insert.
–
Deactivate Start/Stop syste ...
Removing and installing wheel bearing unit, torsion beam axle
Special tools and workshop equipment required
Fitting sleeve -3241/4-
Hub grease cap puller -VW 637/2-
Torque wrench -V.A.G 1332-
Tool insert -T10162 A-
Torque wrench -V.A.G 1410-
...
