VW Golf manuals

Volkswagen Golf Service & Repair Manual: Removing and installing oil level and oil temperature sender -G266-

Removing
–  Drain off engine oil.
   
–  Disconnect electrical connector -3-.
–  Undo nuts -1- and remove oil level and oil temperature sender -G266--item 4-.
Installing
Installation is carried out in the reverse order; note the following:
  Note
Renew seal -2-.
–  Replenish engine oil and check oil level → Booklet.
Specified torques
→ Chapter „Assembly overview - sump and oil pump“
 

Removing and installing oil level and oil temperature sender -G266-

Assembly overview - sump and oil pump
  Note Metal shavings or a large quantity of small metal particles found during engine repair could indicate that the crankshaft bearings or conrod bearings are damaged. To ...

Removing and installing lower part of sump
Special tools and workshop equipment required Flat scraper Commercially available scraper ...

Other materials:

Lifting the vehicle with the jack
Fig. 224 Jacking points Fig. 225 Vehicle jack at the rear left-hand side of the vehicle First read and observe the introductory information and safety warningsThe jack may be applied only at the jacking points shown (markings on the body) . Always use the jacking point closest to the wheel ...

Assembly overview - fuel tank, vehicles with multi-link rear suspension
1 -  Fuel line Vehicles with auxiliary heater To metering pump -V54- Do not kink To pull off, press release button on connection. Plug-in connectors must engage »audibly« when joined. ...

Controls for the air conditioning system
Fig. 181 In the centre console: air conditioning controls (manual) Fig. 182 In the centre console: Climatronic controls First read and observe the introductory information and safety warnings Press the corresponding button to switch a function on or off. Press the button again to switc ...

© 2016-2024 Copyright www.vwgolf.org