Volkswagen Golf Service & Repair Manual: Assembly overview - sump and oil pump
Note
Metal shavings or a large quantity of small metal particles found
during engine repair could indicate that the crankshaft bearings or
conrod bearings are damaged. To avoid any subsequent damage, the
following work must be carried out following the repair: Carefully clean
oil channels and renew oil spray jets, engine oil cooler and oil filter. |
Removing and installing oil spray jets
→ Chapter. |
2 - |
Oil level and oil temperature sender -G266- |
Removing and installing
→ Chapter |
Note
The oil drain plug only has to be replaced if it has a permanent
seal. |
Removing and installing
→ Chapter |
For oil pump drive sprocket |
Before removing, mark running direction with paint. |
Specified torque and tightening sequence
→ Fig. |
Removing and installing
→ Chapter |
Remove and install with oil filter tool -3417-. |
Before installing, lightly coat seal with clean engine oil. |
Removing and installing
→ Chapter |
Tightening sequence → Fig. |
Lower part of sump - specified torque and tightening
sequence |
– |
Tighten bolts in stages in the sequence shown: |
|
|
|
Stage |
Bolts |
Specified torque |
1 |
-1 … 19- |
Screw in to contact by hand |
2 |
-1 … 19- |
12 Nm |
Upper part of sump - specified torque and tightening
sequence |
Note
Renew bolts that are tightened with specified tightening
angle. |
– |
Tighten bolts in stages in the sequence shown: |
|
|
|
Stage |
Bolts |
Specified torque/
additional specified angle |
1 |
-1 … 19- |
Screw in to contact by
hand |
1 |
-1 … 19- |
8 Nm |
2 |
-1 … 19- |
Turn 90° further |
Removing
–
Drain off engine oil.
–
Disconnect electrical connect ...
Other materials:
Removing and installing wiper arm
Special tools and workshop equipment
required
Puller -T10369-
Torque wrench -V.A.G 1331-
Removing
...
Overview of the menu structure
First read and observe the introductory information
and safety warnings The following menu structure shows how the Volkswagen
information system menus in the instrument cluster display are structured. The size
and layout of the Volkswagen information system menu depends on the vehicle electr ...
Assembly overview - add-on parts of heater and air conditioning unit and of
air intake box
Note
There are different designs and makes of heater and air
conditioning unit. The individual components of the various
heaters and air conditioning units are similar but not
identical. The combined fitting of different makes of component ...
© 2016-2024 Copyright www.vwgolf.org