1 - | Retaining plate |
2 - | Interior mirror |
Removing and installing rear lid seal
In the factory a sealant is applied to the rear lid seal, the seal is fitted
to the body flange and then rolled on.
Note
When the seal is removed, the sealant on the inside of the seal will
be spread and the flanks will be bent out slightly. If the seal is then
refitted, sealing and fir ...
Assembly overview – Blind Spot Monitor (Blind Spot Detection)
1 -
Blind Spot Monitor warning lamp in left exterior mirror -K303-
Removing and installing
→ Chapter
2 -
Blind Spot Monitor warning lamp in right exterior mirror -K304-
Removing and installing
...
Warning and indicator lamps
First read and observe the introductory information
and safety warnings
Lit up
Possible cause
Solution
Engine oil level is too low.
Switch off the engine. Check the engine oil level
.
...