VW Golf manuals

Volkswagen Golf Service & Repair Manual: Assembly overview - gas discharge headlight with cornering light and LED daytime running light

Volkswagen Golf Service & Repair Manual / Electrical system / Lights, lamps, switches outside / Headlight / Assembly overview - gas discharge headlight with cornering light and LED daytime running light

Assembly overview - gas discharge headlight with cornering light and LED daytime running light

1 -  Headlight
Removing and installing → Chapter
2 -  Front turn signal bulb
Front left turn signal bulb -M5-
Front right turn signal bulb -M7-
Removing and installing → Chapter
3 -  Cornering light bulb
Left cornering light bulb -L148-
Right cornering light bulb -L149-
Removing and installing → Chapter
4 -  Housing cover
5 -  Gas discharge bulb
With integrated starter unit
Left gas discharge (xenon) bulb -L13-
Right gas discharge (xenon) bulb -L14-
Removing and installing → Chapter
6 -  Headlight range control motor
Left headlight range control motor -V48-
Right headlight range control motor -V49-
Removing and installing → Chapter
7 -  Housing cover
With bolts
Qty. 5
Specified torque: 1.5 Nm
8 -  Bolt
With compensation element
Specified torque: 4 Nm
9 -  Bolt
With compensation element
Specified torque: 8 Nm
10 -  Bolt
Specified torque: 4 Nm
11 -  Output module for headlight
Output module for left headlight -J667-
Output module for right headlight -J668-
Removing and installing → Chapter
Specified torque: 1.7 Nm
12 -  Gas discharge bulb control unit
Left gas discharge bulb control unit -J343-
Right gas discharge bulb control unit -J344-
Removing and installing → Chapter
Specified torque: 1.7 Nm
13 -  Control unit for daytime running light and side light
Control unit for left daytime running light and side light -J860-
Control unit for right daytime running light and side light -J861-
Removing and installing → Chapter
Specified torque: 1.7 Nm
14 -  Cornering light and headlight range control unit -J745-
Removing and installing → Chapter
15 -  Vehicle level sender
Removing and installing → Running gear, axles, steering; Rep. gr.43.
16 -  Stop bolt
For longitudinal adjustment of headlight
17 -  Bolt
With banjo bolt
For height adjustment of headlight
Specified torque: 4 Nm
Assembly overview - gas discharge headlight
1 -  Headlight Removing and installing → Chapter 2 -  Front turn signal bulb Front left turn signal ...

Assembly overview - gas discharge headlight with dynamic high beam control and LED daytime running light
1 -  Headlight Removing and installing → Chapter 2 -  Front turn signal bulb Front left turn signal ...

Other materials:

The dangers of assuming an incorrect sitting position
First read and observe the introductory information and safety warnings If the seat belts are not worn or are worn incorrectly, the risk of severe or fatal injuries increases. Seat belts can only provide optimal protection if the seat belt routing is correct. Assuming an incorrect sitting po ...

Assembly overview – repair kit for headlight housing, does not apply for LED headlights
1 -  Headlight 2 -  Inner retaining tab Removing and installing → Chapter 3 -  Bolt Qty. 1 Specified torque: 2 Nm 4 -  Rear retain ...

Removing and installing drive shaft
Special tools and workshop equipment required     Torque wrench -V.A.G 1332-   Press tool -T10520- ...

© 2016-2020 Copyright www.vwgolf.org